Centrifugal Spray Dryer

Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Centrifugal Spray Dryer
Request a Quote

Description
The pressure atomizer spray drying machine will compress the feeding material into the nozzle atomizer on top of the drying tower, so that the material will be atomized into tiny fog-drops. They will fall down from the top of the tower along with hot air so that it can be dried. Thus, the slurry with higher solid content can be atomized and granulated by pressure. Then it will be dried to form spherical particles. The dried product features good free fluidity.

The centrifugal spray dryer has three kinds of structural layout:

Performance introduction
The atomizer of this centrifugal spray dryer adopts SKF bearing imported from Sweden. The unloaded vibration value of this kind of bearing is smaller than 5um. And the loaded vibration is less than 15um. The whole dryer can run up to 7000h without failures. It can also be equipped with additional vibration system which can be used to clean the powder on the inner wall of the dryer via vibration. The powder can also be cleaned by air sweeper.

The following are some kinds of commonly used centrifugal spray dryer for you to choose from, you can also make some related improvements on the base of various types:
Type
Item
LPG
-5
LPG
-25
LPG
-50
LPG
-100
LPG
-150
LPG
-200
LPG
-500
LPG
-800
LPG
-1000
LPG
-2000
LPG
-3000
LPG
-4500
LPG
-6500
Water evaporation(kg/h) 5 25 50 100 150 200 500 800 1000 2000 3000 4500 6500
Spray type High speed rotary atomizer
Atomizer speed(r/min) 25000 18000 16000 12000-13000 11000-12000
Atomizing diameter (mm) 50 102 108 180-210 Decided according to process requirements
Tower diameter(m) D 0.9 1.75 2.3 2.7 3 3.2 4.7 5.6 6.2 Decided according to process flow, factory condition and user requirements
Floor area length (m) M 1.6 4 4.5 5.2 7 7.5 12.5 13.5 14.5
Floor area width (m) L 0.91 2.7 2.8 3.5 5.5 6 8 12 14
Tower height (m) H 1.75 4.5 5.5 6.7 7.2 8 10 11 15
Nozzle hoisting height (m) H1 - 2.5 2.5 3.2 3.2 3.2 3.2 3.2 3.2
Note: the water evaporation quantity is related with material features, solid content and hot air inlet and outlet temperature.
                           
Main components

Atomizer:cooling device on top of the tower which can be used to reduce the inner wall temperature of the tower.

Hot air distributor: hot air diffuser and hot air distributor
  • Direct-fired combustor control assembly
  • Direct-fired combustor nozzle
  • Pneumatic conveyor

If you have interest on our centrifugal spray dryer, please contact us. If there is no drying machine which can satisfy your requirements, please tell us your demands, and we will provide related solutions according to your requirements.

Related products
Send Message
Other Products
Inquiry
Inquiry